Quick Setup - Runco NLMP22109 Installation & Operation Manual

3.2

Quick Setup

Table 3-1 gives a quick overview of the VX-22i installation process. The sections following
this one provide detailed instructions.
Installation should be performed by a qualified custom video
Note
installation specialist.
Table 3-1. Installation Overview
Step
1 Choose a location for the projector
2 If installing a VX-22i/CineWide or VX-22i/CineWide
with AutoScope: Install fixed CineWide base plate or
AutoScope lens motor
3 Mount the projector
4 Connect signal sources to the projector
5 Connect external controller to RS-232 port (optional)
6 Connect 12-volt trigger outputs to AutoScope lens motor
and/or other equipment (optional)
7 Connect projector and lens motor (if present) to AC power
and power up
8 For rear-screen and/or ceiling-mount installations, select
the proper picture orientation
9 Primary lens adjustments: projected image size (zoom),
position (shift) and focus
10 Install CineWide anamorphic lens (optional)
11 CineWide lens adjustments: position, pitch (angle),
geometry and focus
12 Projector calibration: adjust the following for each input;
save settings when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Input position
Procedure
14
For Details, Refer to
page...
15
22
27
28
33
34
35
36
17, 37
38
40
47
Runco VX-22i Installation/Operation Manual