Quick Setup - Runco D-73d Ultra Installation & Operation Manual

Installation
3.2

Quick Setup

Table 3-1 gives a quick overview of the D-73d installation process. The sections
following this one provide detailed instructions.
Table 3-1. Installation Overview
Step
1 Choose a location for the projector
2 Choose and install a 3D-compatible screen
3 Install CineWide lens mounting assembly (stationary
base plate or AutoScope lens motor – optional)
4 Mount the projector
5 Mount the Dimension Digital Controller
6 Connect the Dimension Digital Controller to the projector
7 Connect other external equipment to the Dimension
Digital Controller (optional):
• Audio processor or secondary display device
• Control system interface (RS-232)
• 12-volt trigger-activated equipment (retractable
screens or screen masking)
• External IR repeater
• Network hub, router or gateway (Ethernet)
8 Connect signal sources to the Dimension Digital
Controller
9 Connect system components to AC power
10 Power up the system and perform optical alignment
procedures (refer to Table 3-6)
11 Display calibration —Dimension Digital Controller:
adjust the following for each input and display mode (res-
olution and frame rate); save settings when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Sharpness
• White Balance
Procedure
22 D-73d Series Installation/Operation Manual
For Details, Refer to
page...
23
24
31
36
37
38
40
45
50
51
68