Image Alignment Controls - Runco LightStyle LS-10d Installation & Operation Manual

Installation
"Keystoning" usually occurs when the projector is tilted relative to the screen. "Pincushion"
distortion can sometimes occur if the throw distance is very short and/or the projector is
equipped with an anamorphic lens.
To correct keystoning or pincushion distortion:
1. On the DHD Controller remote control or front panel, press MENU.
2. Select Calibration from the Main Menu and enter the Calibration Menu passcode.
You must enter a passcode to access the Calibration menu.
Note
3. Select Image Alignment from the Calibration Menu.
4. Select Corner Alignment to correct a "keystoned" image by adjusting the image
corner positions. Select Midpoint Alignment to correct pincushion distortion by
adjusting the image edge mid-points. See Figure 3-19.
Use the built-in test pattern when adjusting the image corners or
Tip
midpoints. To access it, check the Test Pattern box in the Corner
Alignment or Midpoint Alignment menu.
Top Left (x, y)
Left
Middle (x)
Left/Right
Middle (y)
Bottom Left (x, y)
Notes:
1. Smaller "x" values move a point to the left; larger values move it to the right.
2. Smaller "y" values move a point up; larger values move it down.
Figure 3-19. Image Alignment Controls
Top/Bottom Middle (x)
Top Middle (y)
Center
(x, y)
Bottom Middle (y)
44 Runco LS-10d and LS-10HBd Installation/Operation Manual
Top Right (x, y)
Right
Middle
(x)
Bottom Right (x, y)