Adjusting The Projection Angle - Runco LightStyle LS-10d Installation & Operation Manual

If the LS-10 is ceiling-mounted and the screen is significantly lower than the projector, you
can tilt the projector at a slight angle by adjusting the ceiling mount.
The projector can be rotated (side-to-side) up to 360 degrees and mounted without it
affecting performance. However, to ensure optimal performance of the lamp, limit the
front-to-back tilt of the projector to ±20 degrees; see Figure 3-6.
Figure 3-6. Mounting Angle Ranges (Front-to-Back and Side-to-Side)
If you do this, you may need to shift the image using the on-screen display (OSD) controls,
to compensate. For detailed instructions, refer to Primary Lens Adjustments on
page 42.
Runco LS-10d and LS-10HBd Installation/Operation Manual
± 360º
31
Adjusting the Projection
Angle
± 20º
Installation