Controls And Functions; Ls-10 At A Glance - Runco LightStyle LS-10d Installation & Operation Manual

Figure 2-1 and Figure 2-2 show the key LS-10 components.
Status LED
Figure 2-1. LS-10 Front/Side View
• STATUS LED
Indicates projector status as follows:
• Solid green = AC power present, ready to turn on (lamp not lit)
• Flashing green = lamp is warming up or cooling down; keypad functions not allowed
• Off = Lamp lit, projector functioning normally
• Alternating green/red = Lamp problem (door open, unable to strike, end of life), user
intervention likely to fix problem
• Flashing red = Over temperature, user intervention (clear vents, turn on AC) may fix
problem
• Solid red = Error that requires servicing (fan fail, Power-on self-test fail etc.)
• SYSTEM KEYPAD
Not used in this version of the product. Use the DHD Controller to configure and
control the projector.
• EXHAUST VENT
Warm air exits the projector through this vent. Ensure that it is not blocked.
• INTAKE VENT
Internal fans draw cool air into the projector through this vent.
Runco LS-10d and LS-10HBd Installation/Operation Manual

2. Controls and Functions

Exhaust
Vent
Intake
Vent
System Keypad
Projection Lens
5
2.1

LS-10 at a Glance