Ls-10 Rear Panel - Runco LightStyle LS-10d Installation & Operation Manual

Controls and Functions
2.2

LS-10 Rear Panel

Figure 2-3 shows the LS-10 rear panel.
Figure 2-3. LS-10 Rear Panel
1. DHD INPUT
An HDCP-compliant digital video input for connecting the HDMI output from the DHD
Controller.
2. TRIGGER 1
Provides 12 (+/- 1.5) volt switched output for an anamorphic lens transport (if
installed) with 250mA current capacity and short protection.
You can also use a 12-volt trigger output on the DHD Controller to
Note
control the anamorphic lens transport.
3. POWER INPUT (100 to 240 VAC)
Connect the LS-10 to power here.
The other connectors are not used. Connect all signal sources and
Note
other equipment to the DHD Controller.
1 2
8 Runco LS-10d and LS-10HBd Installation/Operation Manual
3