Installing And Adjusting The Anamorphic Lens - Runco LightStyle LS-10d Installation & Operation Manual

If you are installing an LS-10 with an anamorphic lens, proceed as follows to install and
adjust the lens.
It is extremely important that the primary lens is properly
Note
adjusted before you install the anamorphic lens. Ensure that
the image from the primary lens is perfectly centered on the
screen.
Attach the anamorphic lens to the bracket using the plastic knobs supplied with the lens.
See Figure 3-20.
Figure 3-20. Attaching the Anamorphic Lens to the Lens Mount
Configure Lens Motor Trigger on DHD Controller (Optional): The anamorphic lens
solution for the LS-10 maintains constant image height independent of the aspect ratio,
while using the full display resolution of the projector. It accomplishes this by moving the
anamorphic lens in front of the primary lens when widescreen material is being viewed.
When the viewer transitions back to 16:9 or 4:3 source material, the anamorphic lens
moves out of the light path.
If you are using a trigger on the DHD Controller to control the lens transport motor,
proceed as follows to configure it for proper operation.
You can skip this step if you connected the lens transport motor to
Note
the TRIGGER 1 output on the LS-10, as shown in Figure 3-15.
1. Project a 2.35:1 aspect ratio test pattern or other image on the screen.
2. On the DHD Controller remote control or front panel, press MENU.
3. Select Service from the Main Menu and enter the Service Menu passcode.
You must enter a passcode to access the Service menu for the first
Note
time after turning on the system.
Runco LS-10d and LS-10HBd Installation/Operation Manual 45
Installation
3.11
Installing and
Adjusting the
Anamorphic Lens