Runco LightStyle LS-10d Installation & Operation Manual page 80

Operation
Display Color
RGBW
Red x
Red y
Green x
Green y
Blue x
Blue y
White x
White y
Auto Color Enable
Test Pattern Enable
• PCE: To use the Personal Color Equalizer to define a custom color gamut, choose the
"PCE" Color Gamut setting (refer to Color Gamut on page 63). Then, choose PCE
from the Display Color - Common Settings menu and press ENTER.
Note
PCE provides the ability to define a custom color gamut in terms of a "white point" and
primary (red, green, blue) and secondary (yellow, cyan and magenta) color points; see
Figure 4-7.
• RGBW (Red, Green, Blue, White): To precisely adjust the primary color points and
white point associated with the custom color gamut, choose RGBW from the PCE
sub-menu. Each control operates only on the color specified. Surrounding colors are
linearly interpolated based on their distance from each of these colors.
0.640
0.330
The Auto Color Enable and Test Pattern Enable checkboxes let you choose what to
display on-screen while making these adjustments. These controls work together as
0.300
follows:
0.600
0.150
Auto Color Enable
0.060
Setting
0.313
0.329
The DHD Controller uses the PCE settings for all display modes on
a given input.
Test Pattern Enable
Setting
Off Off
Off On
On Off
On On
64 Runco LS-10d and LS-10HBd Installation/Operation Manual
Description
When both boxes are unchecked, the input
signal (normal picture) appears on the
display.
When only the Test Pattern Enable box is
checked, a white "curtain" test pattern
appears instead of the input signal.
When only the Auto Color Enable box is
checked, the input signal appears on the
display.
When you select a red, green, blue, yellow,
cyan or magenta color point to adjust, the
DHD Controller displays only that color
channel. When you select a white point x-
or y-value, all colors are visible (normal
picture).
When both boxes are checked, the DHD
Controller automatically displays a red,
green, blue, yellow, cyan, magenta or white
"curtain" test pattern when you select an x-
or y-value for that color point to adjust.