Runco LightStyle LS-10d Installation & Operation Manual page 85

Table 4-4. Test Patterns and Their Suggested Usage (continued)
Pattern
Grey Bars
Full White
Input Names: You can give each DHD Controller input a descriptive name. For example,
you may want to change the default input name to the type of source component
connected to it: "VCR," "DVD," "Laptop" et cetera. Input names can be up to 12
characters long.
To edit an input name, select Input Names from the Service menu. Press
an input and press ENTER. Use the
or to select a character to change. When you have finished editing the input name,
press ENTER or MENU.
To restore the default input name, press
"Restore" column. Then, press ENTER.
Display Device - Configure: The options in the Display Device - Configure menu allow
you to change the picture orientation, perform lens adjustments or access other,
display-device specific functions.
• Installation – Orientation: Select Installation from the Display Device - Configure
menu, then select Orientation to change the picture orientation to suit the method of
installation (Floor Front, Floor Rear, Ceiling Front or Ceiling Rear). Or, for
front-projection installations, use the Auto setting to have the projector automatically
determine the orientation (floor or ceiling) using an internal sensor.
• Lens: Select Lens from the Display Device - Configure menu to access the motorized
lens controls. Refer to Primary Lens Adjustments on page 42.
• Display Info.: Select Display Info. from the Display Device - Configure menu to obtain
information about the currently-installed lamp: its serial number and number of hours in
use.
Runco LS-10d and LS-10HBd Installation/Operation Manual
Suggested Usage
Use this pattern when making
brightness, contrast or white
balance (gain/offset) adjustments.
Use this pattern when measuring
or adjusting brightness, contrast or
white balance (gain/offset).
or buttons to change a character; press
repeatedly to highlight that input name in the
69
C o mp o s i t e
C o mp o s i t e
or to select
C o mp o s i t e
C o mp o n e n t
H D 1
H D 2
S C A R T
H D M I
H D M I
H D M I
H D M I
Operation
Input Names
Restore
1
Composite 1
2
Composite 2
3
Composite 3
Component
HD 1
HD 2
SCART
1
HDMI 1
2
HDMI 2
3
HDMI 3
4 HDMI 4