Select Motor - Fluke NORMA 4000 Operator's Manual

1. Move the cursor to menu item PI and press Enter.
Menu Motor / Generator Setup is displayed, showing the settings for motor 1
(M1) as shown below.
Adjust the settings as follows:
Line
M1
n1
Drv1
2. If a configuration that suits the measuring layout is already saved, press function
key LOAD, select the configuration.
3. Press Enter to confirm.
4. Adjust configuration as described in the section that follows.

Select Motor

To configure the system for motor 1, go to the "Configure Torque Sensor"
section.
To configure another motor, press Next ... until the respective motor code (M2,
M3 or M4) is displayed.
Configure torque measurement (input, slope and zero) for each motor
Configure speed measurement (speed sensor)
Set type (Type), pole pairs (PPairs) and reference power (Pref)
NORMA Process Interface (Optional)
Configuring the Process Interface
Description
9
esn064.gif
9-5