NORMA 4000/5000
Operators Manual
Five Steps
To set up a configuration, complete the following steps:
For instructions on how to configure the PI1 process interface, please refer to Chapter 9,
"NORMA Analog Interface (Optional)."
For instructions on how to delete a configuration, please refer to chapter 7 "Delete
Configuration."
Call up General Setup and System Information Screen
General Setup
System Information Screen
From the General Setup menu:
This screen shows the basic information about the Power Analyzer:
System
Phases
Options
Serial
Version
7-4
Call up General Setup (optional)
Configure current and voltage channels
Configure average time and synchronization
Configure data transfer to printer and PC
Save configuration
1. Switch on the Power Analyzer and the start screen is displayed.
2. Move the cursor to the menu item General Setup that shows the name of the
currently loaded configuration (in the example following, 1:W3).
3. Press Enter. The General Setup menu is displayed.
1. Press function key Info.... The System Info menu is displayed.
Device type and sample rate
Type and number of equipped power phases
Equipped interfaces and options
Serial number
Firmware version
esn019.gif