Fluke NORMA 4000 Operator's Manual page 144

NORMA 4000/5000
Operators Manual
The current implementation of Fluke NORMA View software is not capable
of configuring the serial adapter settings (baud rate, stop bits, ...) directly.
This must be done manually with a Windows configuration before starting
NORMA View.
Go to:
Settings / Control Panel / Hardware / Device Manager /
Ports (COM & LPT) / ATEN USB to Serial Bridge / Port Settings.
Your adapter may get a different virtual COM port number assigned than
shown in the following sample screenshots.
12-6
Note
esn082.gif