Configure Start - Fluke NORMA 4000 Operator's Manual

NORMA 4000/5000
Operators Manual
Menu Integration Setup, second field column State is highlighted.
In the factory configuration 1:W3 the function clear manual (MAN) is
preselected.

Configure Start

You can select different start conditions:
Column
Trig
at
after
Menu Integration Setup, first field column Trig is highlighted.
Menu Integration Setup, first field column at is highlighted.
Date and time for start is taken from the clock in the unit. Correct the date
and time of the unit before you start the integration calculation (chapter 7
"Adjust Date and Time").
7-22
1. Press Enter, select AUTO and confirm with Enter.
Clear values at start is now enabled. If you want to change it, select MAN and
confirm with Enter.
2. Save the configuration settings by pressing the SAVE function key.
Settings
Remote
time
key
-Date-
-
1. Press Enter, select start condition and confirm with Enter.
2. Start condition is now set. If you have selected a time to start (time) enter the
time in the column at. Proceed as described below:
1. Press Enter, select year, month, day, hour minute and seconds with the cursors
and confirm with Enter.
Start time is now set.
2. Save the configuration settings by pressing the SAVE function key..
Note
Description
Start via Interface command
Start on date and time
Start when key pressed (Key F1)
Start time(only active at Trig time)
No function
Note