Setting Rgb Delay (Crosspoint 450 Plus Switchers Only); Example 6: Setting The Rgb Delay For An Output - Extron electronics CrossPoint 450 Plus Series User Manual

Operation, cont'd

Setting RGB delay (CrossPoint 450 Plus switchers only)

The CrossPoint 450 Plus switchers can briefly blank the RGB (video) output while it
switches to the new input's sync source, and then switches the RGB signals. This
allows a brief delay for the display to adjust to the selected input's sync timing
before displaying the new picture, which will appear without glitches. RGB delay,
also known as Triple-Action Switching or video mute switching, is user selectable
from 0 to 5 seconds, in half-second increments.
The RGB delay interval can be set on the front panel or by using either serial port or
the Ethernet port and either the SIS, Windows control program, or HTML pages
(see chapter 4, "Programmer's Guide", chapter 5, "Matrix Software", and chapter 6,
"HTML operation". Specify the RGB delay interval for a specific output on the
front panel as follows:
1.
2.
3.
4.
5.

Example 6: Setting the RGB delay for an output

In the following example, the RGB delay is increased for output 17. The steps show
the front panel indications that result from your action.
1.
Figure 3-37 — Clear all selections
3-26 CrossPoint 450 Plus and MAV Plus Switchers • Operation
RGB delay is protected when front panel lock mode 2 is selected. You can
view the delay in lock mode 2, but not change it from the front panel.
Press the Esc button to clear any input buttons, output buttons, or control
buttons that may be lit.
To enter RGB Delay mode, press and hold the RGBHV button until the button
begins to blink green, then release the button.
Press and release an output button to select an output. Each lit input button,
from Input 1 through Input 10, indicates a half second of RGB delay interval
for the selected output.
Press and release the Esc (
the interval.
Press and release the RGBHV button to exit the RGB Delay mode. The
RGBHV button stops blinking.
• Pressing the Enter or Preset button also exits RGB Delay mode. Pressing
the Preset button changes to Recall Preset mode.
• The RGB interval for each output is stored in non-volatile memory. When
power is removed and restored, the delay settings are retained.
• Exiting RGB Delay mode by pressing the RGBHV button always returns
the I/O configuration to audio only selected for configuration.
Press and release the Esc button (figure 3-37).
Press the Esc button to clear all
C O N T R O L
VIEW ESC
ENTER PRESET
The button flashes once.
) and View ( ) buttons to increase and decrease
selections.