Setting Rgb Delay (Vga And Rgbhv Boards Only) - Extron electronics SMX Series User Manual

Operation and Setup, cont'd
5.
Figure 3-14 — Saving or recalling a plane preset

Setting RGB Delay (VGA and RGBHV boards only)

N This feature is only applicable for VGA and RGBHV boards, and can not be set
1.
2.
3.
4.
5.
N No input buttons lit equals zero delay, 10 buttons lit equals 5 seconds delay.
Step 2.
Press and release a VGA or RGBHV plane button (lights green or amber).
Step 3.
Press and hold the View button until the plane button flashes green.
Step 4.
Press and release the desired output button to be delayed (here output 8).
Input buttons light to show the current RGB delay (here 2.5 seconds).
Figure 3-15 — Setting RGB delay
6.
3-12 SMX System MultiMatrix Switchers • Operation and Setup
Press and release the Enter button. The plane preset is saved or recalled.
Step 3.
Press desired plane button (here plane 0). The plane button lights.
I/O PLANE SELECT
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
0
Plane button lights amber.
Buttons for any previously saved plane presets light red (here preset #7).
Step 4.
Press and release the desired (unlit or lit) input button 1-10
(here preset #3). The selected button flashes red.
INPUTS
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
OUTPUTS
Enter button also blinks (red).
To recall a plane preset – Press and release the Preset button.
N
Select a plane, then press and release a lit Preset button.
via the front panel when in Lock modes 1 and 2.
Press the Esc button to clear all pending changes (flashes green once).
Select a VGA or RGBHV plane.
Press and hold View for 3 seconds. The selected plane button flashes green.
Select the output to delay (button lights).
Using View ( ) and Esc (
<
5 seconds maximum. Each lit input button corresponds to half a second delay.
I/O PLANE SELECT
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
C O N T R O L
0
ENTER PRESET VIEW ESC
INPUTS
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
OUTPUTS
Press Enter to save the settings and exit the RGB delay mode.
) adjust the time duration for the delay, up to
>
I/O PLANE SELECT
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Step 5. Press View (to decrease) or Esc (to increase)
to adjust. Maximum RGB delay is 5 seconds).
Step 5.
Press the Enter button to
save or recall the preset.
C O N T R O L
ENTER PRESET VIEW ESC
All buttons extinguish.
C O N T R O L
VIEW ESC
ENTER PRESET