Hp Dl320 G4 Bios Settings - Nortel 1000 Applications Installation And Commissioning

126 COTS Servers

HP DL320 G4 BIOS settings

The Basic Input Output System (BIOS) settings on the HP DL320
G4 server shipped through Nortel are correct. The BIOS settings do
not require adjustment unless they are reset due to a fault or through
maintenance. If a reset of the BIOS settings occurs, check the serial port
option. The HP DL320 G4 BIOS settings can be seen at
DL320 G4 default BIOS settings" (page
provide a physical COM1 serial port and a virtual (ILO) COM2 serial port.
If the setting for the serial console port is Auto, output can be directed
to either the COM1 port or COM2 ILO port. Set the serial console port
option to COM1 to ensure the console output goes to the physical COM1.
See
126)
The HP DL320 G4 server shipped through Nortel has a default baud rate
of 9600 b/ps and does not require a reset. If an error occurs and you want
to reset the baud rate, or if you want to change to another baud rate, see
"Changing the baud rate on an HP DL320 G4 Signaling Server" (page
128)
For information about how to enable or disable the BIOS password on
the HP DL320 G4 server see
password" (page
Table 6
HP DL320 G4 default BIOS settings
BIOS value
Devices and I/O port - serial port A
Devices and I/O port - baud rate
Devices and I/O port - type of connector
Start options - legacy USB support
Configure the COM1 serial port on an HP DL320 G4 server
Step
1
Linux Platform Base and Applications Installation and Commissioning
Copyright © 2007–2008 Nortel Networks
.
"Configure the COM1 serial port on an HP DL320 G4 server" (page
for instructions.
for instructions.
130).
Action
Press Power to boot the server.
The server boots and the HP DL320 G4 boot screen appears.
Nortel Communication Server 1000
NN43001-315 02.09
29 October 2008
126). The HP DL320 G4 servers
"Setting the HP DL320 G4 server BIOS
Default setting
Enabled
9600 baud
9-pin serial female
Disabled
Table 6 "HP