Nortel 1000 Applications Installation And Commissioning page 31

3
4
5
6
7
8
9
10
11
12
13
This procedure describes upgrading the Backup ECM Security server from
Rls 5.00 to Rls 5.50.
Upgrade Backup ECM Security server
Linux Platform Base and Applications Installation and Commissioning
Copyright © 2007–2008 Nortel Networks
.
Enter the root user password when prompted.
Execute the following script:
/opt/nortel/isclient/setup_ssha.sh deconfig
If a Backup ECM Security server is present in the system, switch
user to the root account and execute the script
/opt/nortel/isclient/failOver.sh <FQDN of Primary
ECM Security Server>
where <FQDN of Primary ECM Security Server> is set to the
FQDN of the Primary ECM Security server.
Wait for two minutes after the command completes before
proceeding.
Switch user back to the nortel account by typing exit.
Perform the "Upgrading Nortel Linux base " (page 54)
up to and including Step
Switch user to the root account and disable network connectivity
to the TLAN ethernet port with the command:
ifconfig eth1 down
WARNING
This shuts down the eth1 port.
When complete, switch back to the nortel account.
Continue with Step 15
(page 54) procedure.
Open a command line interface session to the Primary ECM
Security Server through the serial port with the nortel account.
Install the following patches onto the Primary ECM Security
server using the "Patching Operation" (page 106)
•
MPLR25520
•
MPLR25521
Nortel Communication Server 1000
NN43001-315 02.09
29 October 2008
ECM Upgrade Procedures 31
14.
of the "Upgrading Nortel Linux base "
--End--
procedure
procedure.