Set Up The Nt6D11Ab, Nt6D11Ae, Nt6D11Af Dchi; Dip Switch Settings - Nortel Communication Server 1000S Installation And Configuration Manual

Page 102 of 394

Set up the NT6D11AB, NT6D11AE, NT6D11AF DCHI

DIP switch settings

553-3001-201 Standard 2.00
DCH installation
Note: To configure J1, the asynchronous port on the DCHI card, refer to
the documentation of the application being interfaced, and to
Circuit Card: Description and Installation (553-3001-211). J1
configuration is not described in this NTP.
The NT6D11AB/AE/AF has three sets of DIP switches. Each port has its own
bank of 10 DIP switches (SW1 & SW2) to select the port address (8 bits) and
mode of operation (2 bits). SW1 is used for port 0 settings, SW2 is used for
port 1 settings. SW3 is used to select the D-channel protocol. Port 0 is used
to select whether the asynchronous ESDI port is be disabled or not.
Port 1 is used to select the standard or expanded D-channel addressing mode
on the NT6D11AB/AE/AF.
September 2004