Nortel 1000 Applications Installation And Commissioning page 36

36 Install Nortel Linux base
The base parameters can be changed after the installation is complete
using the CLI command baseparamsconfig. A change in the base
parameters can affect other application components. For example, if
the current server is the Primary ECM security server and the FQDN is
changed it is necessary to reinstall the applications.
The CLI command baseparamsconfig is an umbrella command that
you can use to configure parameters for network settings, Network Time
Protocol settings, date and time settings, and DNS settings. You can
configure these parameters individually by using the CLI commands
Linux Platform Base and Applications Installation and Commissioning
Copyright © 2007–2008 Nortel Networks
.
—
The domain name
Note:
A Fully Qualified Domain Name (FQDN) consists of a
host name and a domain name, and includes a top-level domain
name. Using kwei.ca.nortel.com as an example, kwei is the
host name, ca.nortel.com is the domain name, and .com is the
top-level domain name. The FQDN must contain at least three
fields separated by dots.
—
TLAN IP address
—
TLAN gateway IP address
—
TLAN netmask
—
Timezone
—
IP address of Network Time Protocol (NTP) Server
—
IP address of the Primary Domain Name Service (DNS) server
—
Default system gateway associated with the network interface
(ELAN or TLAN)
Note 1:
The choice of ELAN or TLAN as the default gateway
NIC can be influenced by the applications that you are going to
deploy on the server and by network topology. For a definition of
ELAN and TLAN see
Note 2:
The CLI command routeconfig can be used to add
routing entries. The choice of routing entries will depend upon
the network topology and application deployment. For a list of
Nortel Linux base CLI commands see
base CLI commands" (page
Nortel Communication Server 1000
NN43001-315 02.09
29 October 2008
"Network configuration" (page
Table 11 "Nortel Linux
141).
143).