46 Install Nortel Linux base
Figure 26
NTP clock source configuration window
17
Figure 27
DNS server configuration window
18
Linux Platform Base and Applications Installation and Commissioning
Copyright © 2007–2008 Nortel Networks
.
Press Enter to continue.
At the prompt, configure the primary DNS server IP address as
shown in
Figure 27 "DNS server configuration window" (page
46).
Type Y to configure and N if you do not wish to configure and
then press Enter. If you selected Y , enter the IP address for the
Primary DNS server at the prompt. The default for the Primary
DNS server is N.
In the Configuration Validation 2 screen, type Y if the
information is correct and press Enter, as shown in n the
Figure 28 "Configuration Validation 2 window" (page
information is incorrect, type N, make the required changes, and
then press Enter.
Note: The CLI command hostconfig can be used to modify
the static lookup table for host names. For a list of Nortel
Linux base CLI commands see
CLI commands" (page 141)
Nortel Communication Server 1000
NN43001-315 02.09
29 October 2008
47). If the
Table 11 "Nortel Linux base