There are several procedures in this section. Perform the first procedure
based on your system configuration:
•
•
•
Then perform one or both of the following procedures as applicable to your
system configuration:
•
•
This procedure describes upgrading the Primary ECM Security server from
Rls 5.00 to Rls 5.50 in a configuration with no Backup ECM server and
less than three or no Member servers associated with it.
1a: Upgrade Primary server without Backup server and less than three or no
Member servers
Step
There are no prerequisites for this procedure.
1
2
3
4
This procedure describes upgrading the Primary ECM Security server from
Rls 5.00 to Rls 5.50 in a configuration with a Backup ECM server and less
than three or no Member servers associated with it.
1b: Upgrade Primary server without Backup server and less than three or no
Member servers
Linux Platform Base and Applications Installation and Commissioning
Copyright © 2007–2008 Nortel Networks
.
"1a: Upgrade Primary server without Backup server and less than
three or no Member servers" (page 29)
"1b: Upgrade Primary server without Backup server and less than
three or no Member servers" (page 29)
"1c: Upgrade Primary server with Backup server and three or more
Member servers" (page 30)
"Upgrade Backup ECM Security server" (page 31)
"Upgrade ECM Member server" (page 33)
Action
Open a command line interface session to the Primary ECM
Security Server through the serial port with the nortel account.
Perform the
"Upgrading Nortel Linux base " (page 54)
Open a command line interface session to the Primary ECM
Security Server through the serial port with the nortel account.
Install the following patches onto the Primary ECM Security
server using the
•
MPLR25520
•
MPLR25521
Nortel Communication Server 1000
NN43001-315 02.09
29 October 2008
ECM Upgrade Procedures 29
"Patching Operation" (page 106)
--End--
procedure.
procedure.