4.17 RTC battery
Removing the RTC battery
To remove the RTC battery, follow the steps below and refer to Figure 4-26.
1. Peel off the glass tape.
2. Disconnect the RTC battery cable from the connector CN9300 on the system board
and remove the RTC battery.
RTC battery cable
Installing the RTC battery
To install the RTC battery, follow the steps below and refer to Figure 4-26.
1. Connect the RTC battery cable to the connector CN9300 on the system board.
2. Arrange the RTC battery cable while passing under the hook.
3. Seat the RTC battery in place and stick the glass tape.
TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573)
CN9300
Figure 4-26 Removing the RTC battery
4 Replacement Procedures
Glass tape
RTC battery
Hook
[CONFIDENTIAL]
4-43