Fingerprint Sensor Board - Toshiba Tecra A8 Maintenance Manual

4.12 Fingerprint sensor board

4.12 Fingerprint sensor board

Removing the Fingerprint sensor board
To remove the fingerprint sensor board, follow the steps below and refer to Figure 4-20.
1. Turn up the insulator and peel off the glass tape.
2. Remove the fingerprint sensor board hold plate while sliding it in the direction of
the arrow in the figure below.
3. Remove the fingerprint sensor board fixed with the double-sided tape and peel off
the tape that prevents a waterdrop from entering the computer.
4. Disconnect the fingerprint sensor cable from the connector on the fingerprint sensor
board.
Fingerprint sensor board hold plate
Fingerprint sensor board
Double-sided tape
Figure 4-20 Removing the fingerprint sensor board
TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573)
4 Replacement Procedures
Glass tape
Fingerprint sensor cable
Insulator
[CONFIDENTIAL] 4-33