Mdc/Memory Module - Toshiba Tecra A8 Maintenance Manual

4 Replacement Procedures
4.6

MDC/Memory module

Removing the MDC/Memory module
To remove the MDC/memory module, follow the steps below and refer to Figure 4-8 and 4-9.
1. Loosen the screw (with a washer) and remove the MDC/memory cover.
2. Remove the following screws securing the MDC.
•
M2×4B
3. Lift up the insulator and disconnect the MDC from the CN3010 on the system board.
4. Disconnect the MDC cable from the connector on the MDC.
MDC/Memory cover
4-16 [CONFIDENTIAL]
×2
BIND screw
MDC
Insulator
Figure 4-8 Removing the MDC
TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573)

4.6 MDC/Memory module

Screw (with a washer)
M2×4B BIND
MDC cable
CN3010