Toshiba Tecra A8 Maintenance Manual page 235

3.30 SETUP
NOTE: 1. Do not remove the AC adapter and battery pack at the same time when you use
this feature. If you do so, data saved by the resume function will be lost. You
must also reset this option.
2. When a password is set in Password Security, the system is in standby mode,
the Timer on function (Auto Power PN) is set and the system is booted,
"Password =" is displayed. When the password set in Password Security is
input, the computer returns to Windows from standby mode.
3. This function is effective only once, it is released after booting up.
(f) Beep Volume
This option selects the volume of beep (Warning). "OFF", "Low", "Medium"
(Default) or "High" can be selected. If a memory module that does not comply
with the standards, the computer beeps at maximum volume.
(g) Diagnostic Mode
This option sets whether the BIOS Setup Diagnostic test is enabled.
Disabled
Enabled
(h) Language During Bootup
This option selects the language during bootup. This message appears only on
the model for TCL (Canada).
English
French
8. Configuration
This option displays the configuration method.
(a) Device Config.
The devices are initialized when the PNP OS loads.
Setup by OS
All Devices
If you are using an OS that does not have PNP capacity, select "All Devices."
The Display shows the following message:
Device Config. = All Devices
TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573)
The Diagnostic test is disabled. (Default)
The Diagnostic test is enabled.
The message is displayed in English. (Default)
The message is displayed in French.
Initializes devices, which is needed to load an operating
system. Operating system initializes other devices.
(Default)
All devices will be initialized.
3 Tests and Diagnostics
[CONFIDENTIAL] 3-101