Network Card Option Service Check; 250/250 Dual Paper Tray Service Check - Lexmark Optra C710 Service Manual

5016-001

Network Card Option Service Check

Error Code 976 - Network Card X (X=Network card 1, 2, or 3)
A 976 error code indicates an unrecoverable software error in
network card x. Verify that network card x is correctly installed in the
socket on the interconnect board and is properly grounded. If you
find no problem, contact your next level of support, before replacing
the network card.
Error Code 977 - Network Card X
A 977 error displays when the RIP software detects a network card
is installed in slot x, on the interconnect board, but cannot establish
communications with the network card. If a network card works in
another slot, replace the interconnect board.

250/250 Dual Paper Tray Service Check

The 250/250 sheet dual tray option uses two of the same paper feed
units that are in tray 1. Also included are idler rollers above the
paper feed unit and paper guides on the side of the paper feed
opening. An interconnect board assembly, drive module and LVPS
for the option is located on the right side frame.
Note: Check the following before proceeding with this service
check:
•
Be sure the media feeds correctly from integrated tray (tray 1).
•
Be sure the primary power cord is plugged into the 250/250
option base unit and the option power cord into the printer.
If the duplex option is installed, plug the 250/250 option power
cord into the bottom tray of the duplex unit and plug the duplex
unit power cord into the printer.
•
Be sure the printer is correctly installed over the 250/250 tray
option, or over the duplex option, if installed.
•
Be sure media in the trays is within specifications. Be sure the
following are not fed from tray 2 or 3.
– 16 lb. paper should only be loaded in tray 1 or MPT.
– Labels and card stock should be fed from the MPT only.
– Transparencies should be fed from tray 1 or the MPT only.
– Envelopes should be fed from the MPT.
2-108
Service Manual