Lexmark Optra C710 Service Manual page 83

5016-001
Message
35 Res Save Off
Deficient Memory
37 Insufficient
Collation Area
37 Insufficient
Defrag Memory
Status
The printer lacks the
memory needed to enable
the Resource Save
function. This message
usually indicates that too
much memory is allocated
for one or more of the
printer link buffers.
The printer memory (or
optional hard disk, if
installed) does not have
the space necessary to
collate the print job.
The printer is unable to
perform the requested
Flash Memory
Defragment operation
because the printer does
not have enough memory.
This message is posted
before the operation
begins to ensure items in
flash memory are not lost.
Action
To disable Resource Save
and continue printing, press
.
Go
To enable Resource Save
after you get this message,
perform one of the following:
• Set the link buffer for
each interface to Auto.
Then exit the menus to
activate the link buffer
changes. When the
message is
Ready
displayed, enable
Resource Save from the
Setup Menu.
• Install additional printer
memory.
Press to print the portion
Go
of the job already stored and
begin collating the rest of
the job.
To cancel the print job:
• Press
Menu>
until the Job Menu is
displayed.
• Press
Menu>
until Cancel Job appears
on the second line.
• Press
Select
Press to clear the
Go
message.
If you want to perform the
defragment operation,
delete fonts, macros, and
other data in RAM and try
again or install more
memory.
Diagnostic Information
or
<Menu
or
<Menu
.
2-17