Lexmark Optra C710 Service Manual page 74

5016-001
Message
Waiting
Not Ready
Ready Hex
Locking Menus
2-8
Service Manual
Status
The printer has received a
page of data to print but is
waiting for an End of Job or
Form Feed command or for
additional data.
The printer is not ready to
receive or process data,
because someone selected
when another
Stop
message was displayed.
Hex Trace diagnostic mode
is active, and the printer is
ready to receive data.
Use Hex Trace to isolate
the source of a print job
problem. With Hex Trace
selected, all data sent to
the printer is printed in
hexadecimal and character
representation.
Control code strings are
printed, not executed.
Someone has locked the
menus. While the menus
are locked, users cannot
change the printer default
settings from the operator
panel.
Action
• To print the contents of
the print buffer, press
Go.
• To cancel the print job,
press or
Menu>
until the Job Menu is
displayed. Press
Press or
Menu>
until Cancel Job appears
on the second line.
Press .
Select
• Press to remove the
Go
printer from the Not
Ready state.
• To cancel the print job,
press or
Menu>
until the Job Menu is
displayed. Press
Press or
Menu>
until Cancel Job appears
on the second line.
Press .
Select
• To exit Hex Trace mode,
turn the printer off or
reset the printer.
• To reset the printer,
press or
Menu>
When the Job Menu is
displayed press
Press or
Menu>
until Reset Printer
appears on the second
line. Press
Select
N/A
<Menu
.
Select
<Menu
<Menu
.
Select
<Menu
.
<Menu
.
Select
<Menu
.