Hard Disk Option Service Check - Lexmark Optra C710 Service Manual

5016-001

Hard Disk Option Service Check

Verify the hard disk and the hard disk board are correctly installed.
When a problem is suspected, either with the hard disk system
board or the hard disk, run the
Note: The Quick Disk Test is a non-destructive test and indicates
pass or fail. If the test fails, replace the hard disk. If a problem still
exists, replace the hard disk board.
The "Disk Test/Clean" on page 3-17
the disk is unusable, or contains bad data. This test is divided into a
cleaning and a verifying or testing section.
Note: This test leaves the hard disk unformatted and can be a very
lengthy test, depending on disk size. The servicer, or user, must
reformat the disk using the Format Disk Menu operation. The test
destroys all data and should not be performed on a known good
disk.
"Quick Disk Test" on page
is used to restore the disk, if
Diagnostic Information
3-16.
2-107