Using The Prtdiag Command; Options - Fujitsu SPARC Enterprise M3000 Service Manual

The following example shows output for the iostat command:
# iostat -En
c0t0d0 Soft Errors: 0 Hard Errors: 0 Transport Errors: 0
Model: ST3120026A
Size: 120.03GB <120031641600 bytes>
Media Error: 0 Device Not Ready: 0
Illegal Request: 0
c0t2d0 Soft Errors: 0 Hard Errors: 0 Transport Errors: 0
Vendor: LITE-ON
Size: 0.00GB <0 bytes>
Media Error: 0 Device Not Ready: 0 No Device: 0 Recoverable: 0
Illegal Request: 0 Predictive Failure Analysis: 0
3.6.2

Using the prtdiag Command

The prtdiag command displays system configuration and diagnostic information.
The diagnostic information identifies any failed FRU in the system.
The prtdiag command is located in the /usr/platform/platform-name/sbin/
directory.
The prtdiag command may indicate a slot number different from that shown
elsewhere in this document. This is normal.
3.6.2.1

Options

TABLE 3-8
troubleshooting.
Options for prtdiag
TABLE 3-8
Option Description
No option Lists components.
Verbose mode.
-v
Revision: 8.01
Product: COMBO SOHC-4832K Revision: O3K1 Serial No:
lists the options of the prtdiag command and how those options can help
Serial No: 3JT4H4C2
No Device: 0 Recoverable: 0
How it can help
Shows CPU information, memory
configuration, PCIe cards installed, OBP
version, status of the mode switch, and CPU
operation mode.
Provides the same information as no option.
Additionally, displays the detail information
of PCIe cards.
Chapter 3 Troubleshooting 3-21