Installing The Dimms; Reassembling The Server - Fujitsu SPARC Enterprise M3000 Service Manual

7.4

Installing the DIMMs

1. Push the DIMM evenly into the DIMM socket.
2. Push the DIMM eject levers inward to secure the DIMM in position.
When mounting DIMMs, align the indentation with the corresponding connector
part.
7.5

Reassembling the Server

1. Attach the air duct.
For details, see
2. Attach the top cover.
For details, see
3. If the equipment rack is supplied with a Quake-Resistant Options Kit or
stabilizer, return to its original position.
For details, see
page
4. Power on the server.
This procedure includes the steps of reconnecting the power cord, checking the
LED status, and turning the mode switch on the operator panel to the Locked
position. For details, see
Command" on page
Note – If automatic startup of the Oracle Solaris OS is specified, use the sendbreak
-d domain_id command of the XSCF Shell to display the ok prompt after the
display console banner is displayed but before the system starts booting the Oracle
Solaris OS.
5. Check the hardware.
This procedure includes the steps for running a program to verify that all the
components have been remounted and to start the Oracle Solaris OS.
For details, see
Section 5.3.2, "Attaching the Air Duct" on page
Section 5.2.2, "Attaching the Top Cover" on page
Section 5.1.2, "Sliding the Server into the Equipment Rack" on
5-3.
Section 4.5.3.1, "Power-on by Using the XSCF
4-13.
Section 4.5.4, "Verifying the Hardware Operation" on page
Chapter 7 Replacement and Installation of Memory
5-6.
5-4.
4-15.
7-9