User Safety Summary - Tektronix Z740/DX - Phaser 740 Extended Color Laser Printer Instruction Manual

User safety summary

Terms in manual:
CAUTION
WARNING
Power source:
Do not apply more than 250 volts RMS between the supply conductors or between either supply conductor
or ground. Use only the specified power cord and connector. Refer to a qualified service technician for changes to the cord
or connector.
Operation of product:
Avoid electric shock by contacting a qualified service technician to replace fuses inside the product.
Do not operate without the covers and panels properly installed. Do not operate in an atmosphere of explosive gases.
Safety instructions:
Read all installation instructions carefully before you plug the product into a power source.
Terms on product:
CAUTION
DANGER
Care of product:
Disconnect the power plug by pulling the plug, not the cord. Disconnect the power plug if the power cord
or plug is frayed or otherwise damaged, if you spill anything into the case, if product is exposed to any excess moisture, if
product is dropped or damaged, if you suspect that the product needs servicing or repair, and whenever you clean the
product.
Ground the product:
Plug the three-wire power cord (with grounding prong) into grounded AC outlets only. If necessary,
contact a licensed electrician to install a properly grounded outlet.
Symbols as marked on product:
DANGER high voltage:
Hot surface on or in the printer.
Use caution to avoid personal
injury:
WARNING:
If the product loses the ground connection, usage of knobs and controls (and other conductive
parts) can cause an electrical shock. Electrical product may be hazardous if misused.
WARNING:
For your protection, do not defeat any interlocks.
CAUTION:
This product utilizes a laser. Use of control or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure. Do not open covers and do not repair yourself. Refer servicing
to qualified personnel.
Conditions that can result in damage to the product.
Conditions that can result in personal injury or loss of life.
A personal injury hazard exists that may not be apparent. For example, a
panel may cover the hazardous area. Also applies to a hazard to property
including the product itself.
A personal injury hazard exists in the area where you see the sign.
Protective ground (earth) terminal:
This product is certified under IEC
825 as a Class 1 Laser Product:
Use caution. Refer to the manual(s)
for information: