Users Safety Summary - Tektronix PHASER 780 Service Quick Reference Manual

Users safety summary

Terms in CAUTION
manual: WARNING
Power source: For 110 VAC printers, Do not apply more than 130 volts RMS
between the supply conductors or between either supply conductor and ground.
Use only the specified power cord and connector. For 220 VAC printers, Do not
apply more than 250 volts RMS between the supply conductors or between either
supply conductor and ground. Use only the specified power cord and
connector.Refer to a qualified service technician for changes to the cord or
connector.
Operation of product:
technician to replace fuses inside the product. Do not operate without the covers
and panels properly installed. Do not operate in an atmosphere of explosive
gases.
WARNING
not de-energize the printer. You must remove the power cord to
disconnect the printer from the mains. Keep the power cord
accessible for removal in case of an emergency.
Safety instructions:
product into a power source.
Terms on CAUTION
product:
apparent. For example, a panel may cover the hazardous area.
Also applies to a hazard to property including the product itself.
DANGER
Care of product: Disconnect the power plug by pulling the plug, not the cord.
Disconnect the power plug if the power cord or plug is frayed or otherwise
damaged, if you spill anything into the case, if product is exposed to any excess
moisture, if product is dropped or damaged, if you suspect that the product needs
servicing or repair, and whenever you clean the product.
Ground the product:
grounded AC outlets only. If necessary, contact a licensed electrician to install a
properly grounded outlet.
Conditions that can result in damage to the product.
Conditions that can result in personal injury
or loss of life.
Avoid electric shock by contacting a qualified service
Turning the power off using the On/Off switch does
Read all installation instructions carefully before you plug the
A personal injury hazard exists that may not be
A personal injury hazard exists in the area where
you see the sign.
Plug the three-wire power cord (with grounding prong) into