Duplicating The Keys; Emergency Starting - Ferrari 612 scaglietti Owner's Manual

Duplicating the keys

1
When ordering additional keys, remember that the memorisation
procedure (up to maximum of 7 keys) must be carried out on all the
keys, including those already in your possession. Directly contact the
Ferrari Service Network , bringing with you all the keys in your
possession, the Ferrari CODE system CODE CARD , a personal ID
and the identification and registration documents proving ownership
of the vehicle. The codes of the keys that are not available when the
new memorisation procedure is performed will be deleted from the
memory, in order to prevent that any lost or stolen keys are used to
start the vehicle.

Emergency starting

If the Ferrari CODE fails to disable the engine immobilizer, the
warning light CODE will remain illuminated, the warning light EOBD
will turn off after four seconds and then will come on immediately;
the engine will not start. The engine can only be started with the
emergency procedure.
We recommend that you read the whole procedure carefully before carrying
it out.
If you make a mistake, you should turn the ignition key to 0 and repeat
the operations from step 1.
1) Read the 5-digit electronic code found on the CODE CARD.
2) Turn the ignition key to position II: at this moment the CODE and
EOBD warning lights are on.
3) Depress the accelerator pedal and hold it down. After
approximately 8 seconds the EOBD warning light goes off. Release
the accelerator and get ready to count the number of times the
EOBD warning light flashes.
4) As soon as the number of flashing is equal to the first digit of your
CODE CARD, depress the accelerator pedal and hold it down until
the EOBD warning light goes off (after approximately 4 seconds).
You can now release the accelerator pedal.
5) The EOBD warning light starts flashing again. as soon as the
8
number of flashing is equal to the second digit of your CODE
CARD, depress the accelerator and hold it down.
6) Follow the same procedure for the remaining digits in the code on
the CODE CARD.
7) When the last digit has been entered, keep the accelerator pedal
pressed down. The EOBD warning light comes on for 4 seconds
and then goes off. You can now release the accelerator pedal.
8) A quick flashing of the EOBD warning light (about 4 seconds)
confirms that procedure has been carried out correctly.
9) Start the engine turning the key from II to III.
If the EOBD warning light remains on, turn the key to 0 and repeat the
procedure from step 1.
This procedure can be repeated an unlimited number of times.
After an emergency staring, you should contact the F
N otherwise you will have to perform the emergency procedure every
ETWORK
time the engine is started.
S
ERRARI ERVICE