Duplicating The Keys - Ferrari 488GT Owner's Manual

Table of Contents

Advertisement

- While driving with the engine running:
1) If the CODE warning light
A
turns on, it means that the system
is performing a self-diagnostic cycle. At the first opportunity, you
can stop and test the system: when you switch off the engine
and switch it on again by pressing the ENGINE START/STOP
button, the CODE warning light
within one second.
If the warning light stays on, repeat the procedure described
previously after switching the instrument panel off for more
than 30 seconds.
Important note
If the problem persists, please contact the Ferrari Service
Network.
2) If the CODE warning light
A
flashes, it means that the vehicle is
not protected by the immobiliser.
B
A
A
comes on and should go out
Important note
Contact the Ferrari Service Network immediately to have all
the keys stored in the system memory.
Important note
Each key provided has its own specific code, which must be
stored in the memory of the system control unit.

Duplicating the keys

If you request additional keys, provided that the conditions to
satisfy your request are met, remember that the codes must be
stored (up to a maximum of 6 keys) on all the keys.
Contact the Ferrari Service Network directly and bring the
following with you:
- all the keys in your possession;
- the CODE CARD for the Ferrari CODE system;
- a personal identity document;
- the documents proving ownership of the vehicle;
- a report of loss of keys made to the relevant authorities.
The codes for the keys that are not available when the new
memorisation procedure is performed will be deleted from the
memory to prevent any lost or stolen keys being used to start the
vehicle.
1
General
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

488

Table of Contents