Paper Guide Upper Unit Removal - Epson Stylus Pro 5000 Service Manual

Stylus Pro5000

4.2.5.12 Paper Guide Upper Unit Removal

1. Remove carriage unit.(See section 4.2.5.10)
2. Remove a connector of carriage home position sensor from CN5(white,3-
pin) located on the "MB Front Unit".
3. Remove a connector of PE sensor including PR sensor from CN7(white,
5-pin) located on the "MB Front Unit".
4. Remove "Tank, Absorber". (See section 4.2.5.11)
5. Remove "Tension spring,11.7" which is pulling "Lever, PF roller,
Pressing". (Refer to Figure4-47)
6. Remove 8 CBS screws(3x6) and 4 CBP screws(3x8) securing "Paper
Guide Upper Unit" to the mechanism, and remove "Paper Guide Upper
Unit". (Refer to Figure4-48)
CHECK POINT
When re-installing "Paper Guide Upper Unit",
assemble it so that the slider to disengage the
motive power to the pump system is inserted
correctly to the notched parts on the unit.
(See Figure4-48)
Rev. B
Chapter4 Assembly and Disassembly
Tension Spring,11.7
"Lever, PF Roller, Pressing"
Figure 4-47."Tension Spring,11.7" Removal
Notched part and Slider position
CBS(3x6)
Figure 4-48. Paper Guide Upper Unit Removal
CBP(3x8)
CBS(3x6)
4-26