Epson Stylus Pro 5000 Service Manual page 130

Stylus Pro5000
26. Insert "Gear,13.8" into axis "B", and also insert "Lever Assembly,
Planetary, ASF" into the same axis.
27. Fix "Lever Assembly, Planetary, ASF" with "E" shaped ring(#2.3).
(Refer to Figure4-107)
28. Insert "Gear,35.4" into the same axis which "Cam, ASF" is installed.
CHECK POINT
"Gear,35.4" has a small gear behind of it, and this
small gear should face to the mechanism frame
side, when installing it.
CAUTION
At this point, check again that the positioning pin
for alignment is removed from "Combination
Gear,18.144,24". If you continue following
procedures without removing this pin, the gear
train will not work correctly.
Rev.B
Chapter4 Assembly and Disassembly
"Gear,13.8"
Figure 4-107. Installing "Lever Assembly, Planetary, ASF"
"Gear,35.4"
Figure 4-108. Installing "Gear,35.4"
"E" shaped ring
"Lever Assembly,
Planetary, ASF"
4-56