Epson Stylus Pro 5000 Service Manual page 180

Stylus Pro5000
Step3. Connect PC and printer with printer cable and turn both PC
and printer on.
Step4. Type the following sentence on the DOS or DOS Prompt.
C:\mode lpt1:_retry=p
WARNING
Typing this sentence prevents PC from going to
Time Out Error, maintaining the scan mode until
the PC is able to recognize the printer ID correctly,
which comes back from the printer. If this
operation is not performed, the program may hang
up on the initial screen.
Step5. Type as following on the DOS Prompt for exclusive
program Stylus Pro.5000.EXE attached with this manual.
A(In case of FD): \spro.5000.EXE
WARNING
When typing the sentence above, the program
hangs up on the initial screen, if the printer is not
turned on. In this case, start again from Step1.
Step6. Following screen appears.
Figure 5-15. Initial Screen for Stylus Pro5000
Rev. A
CAUTION
If this screen does not appear, following case
might be the reason.
Mode Command is not typed. (Refer to Step4)
Step7. When PC reads the printer ID, the screen in the condition
which "Yes" is selected appears. Then, press Return key.
Step8. Following screen appears.
Figure 5-16. Main Menu Screen
Chapter5 Adjustment
5-12