Epson Stylus Pro 5000 Service Manual page 124

Stylus Pro5000
9. Pressing "Hopper Release Lever Assembly" to right side, rotate 3 holes
on the "Combination Gear,18.144,24" until they become the condition
shown in Figure4-93, and insert the positioning pin for alignment into the
red marked hole(see figure) and pierced it to the hole of the mechanism.
(Refer to Figure4-93)
CAUTION
When inserting the positioning pin, the hole does
not appear unless "Hopper Release Lever
Assembly" is pushed to right side.
10. Slightly adjust the tilt of "Hopper Lock Transmission Gear Assembly" until
the hole of "Hopper Lock Transmission Gear Assembly" can be seen
from the hole on the "Lifter Gear Train Cover Assembly". At the point that
you can confirm the hole, insert the positioning pin for alignment.
"Hopper Release Lever Assembly"
Position to insert
the pin.
Figure 4-93. Adjusting Alignment for "Combination Gear,18.144,24"
Rev.B
"Combination Gear,
18.144,24"
Pin for positioning phase
(Nail in this picture:2mm in
diameter)
"Lifter Gear Train Cover Assembly"
Figure 4-94. Adjusting Alignment for "Hopper Lock Transmission Gear
Chapter4 Assembly and Disassembly
Positioning Pin for Phase
"Hopper Lock Transmission Gear
Assembly"
Assembly"
4-50