Epson Stylus Pro 5000 Service Manual page 23

EPSON Stylus Pro 5000
Table 1-17. Download/Maintenance Mode
Name of
Switch
All switches 1.Manual feed LED turns on when the printer enters this
+ Power on mode correctly. Exclusive starting command( IPL2.HEX )
is transmitted on the DOS (or DOS prompt). Black ink
LED blinks during this transmission and Cyan ink LED
will be turned on when the transmission is completed
correctly.
2.Wait 2 or 3 seconds after the Cyan ink LED is turned
on. Firmware (KEYWEST.HEX ) is transmitted. At this
time, Magenta ink LED is turned one during this
transmission, and Yellow ink LED is turned on when it is
completed.
3.Turn off the power.
Cleaning + I/F 1. After the operation written in the left column
Eject Switch Diseng is performed, press Reset switch until the
+ Power on age black ink LED is turned on. During entering
(Level1) this mode, black, Cyan, Magenta and Yellow
LEDs are turned on alternatively, every time
the reset switch is pressed.
2.When the black ink LED turns on, press
Eject switch to determine.
3.Press the Reset switch until the
corresponding LED turns on, according to the
following explanation.
Black ink LED Automatic, Cyan ink
LED Parallel, Magenta ink LED Serial,
Yellow ink LED Option
4.Press either Eject switch or turn the power
off for registering to EEPROM.
Hexade 1.After the operation written in the left column
cimal is performed, press Reset switch until the
dump Magenta ink LED is turned on. During entering
mode, black, Cyan, Magenta and Yellow LEDs
are turned on alternatively, every time the
Reset switch is pressed. Press Eject switch to
determine after Magenta LED turns on.
2.Turning power off is the only way to escape.
Rev.A
Function
Table 1-18. Download/Maintenance Mode(Cont.)
Name of Switch
Cleaning + Eject P-I/F
Switch + Power on receiving
speed
CG
Disenga
ge
Chapter1 Product Description
Function
1.After the operation written in the left
column is performed, press Reset
switch until the Cyan ink LED is turned
on. During entering this mode, black,
Cyan, Magenta and Yellow LEDs are
turned on alternatively, every time the
reset switch is pressed.
2.Press Eject switch to determine after
Cyan ink LED is turned on.
3.Press the Reset switch until the
corresponding LED turns on, according
to the following explanation.
Black ink LED High speed, Cyan ink
LED Standard
4.Press Eject switch to register in the
EEPROM.
Note)It is not registered to EEPROM, if
power is turned off without pressing
Eject switch.
1. After the operation written in the left
column is performed, press Reset
switch until the Yellow ink LED is turned
on. During entering this mode, black,
Cyan, Magenta and Yellow LEDs are
turned on alternatively, every time the
reset switch is pressed.
2.Press Eject switch to determine after
Yellow ink LED is turned on.
3. Press the reset switch until the
corresponding LED turns on, according
to the following explanation.
Black ink LED PC437, Cyan ink
LED PC850
4. Press Eject switch to register in the
EEPROM.
1-13