Epson Stylus Pro 5000 Service Manual page 138

Stylus Pro5000
40. Fix "ASF Unit" with 2 CBS screws(3x6), and do not forget to remove total
4 positioning pins, which are being inserted into the mechanism at this
point. (Refer to Figure4-121)
WARNING
In case of gear train on the "Frame Assembly,
Middle, Right", if you try to check its operation
forcibly by hand at completing procedures above
and previous pages, arranged alignment will be
dislocated, since "ASF Unit" is not fixed steady to
the mechanism. Therefore, check it operation by
the following procedure. (Go to next page for
procedure)
Rev. B
Chapter4 Assembly and Disassembly
Positioning Pins for phase
Figure 4-121. Removing positioning pins
4-64