Epson Stylus Pro 5000 Service Manual page 212

Stylus Pro5000
Table 6-4. Lubricating Points(Con.)
No. Lubricating Points
17 Teeth surface of "Gear 25.8".
18 Axis of "Frame assembly, DE, Left".
19 "Combination gear 12". (smaller one
compared with a combination gear 26)
20 12 points on "Paper Guide, Front".
21 4 points on "Earth plate, Paper Eject".
22 2 contact areas; between "Roller Assembly,
Paper Eject, Rear" and "Earth plate, Eject".
23 2 contact areas; between "Roller Assembly,
Eject" and "Earth Plate, Eject".
24 2 points; Teeth surface of "Gear 27" located
on both right and left sides.
25 2 points on the axis of "Lever Assembly,
Release Cam".
Note) Do not lubricate the roller surface.
26 Oil pad. Supply oil from the oil supply hole
on the carriage.
Note) Do not lubricate the other area except
oil pad.
27 A hole of "Frame Assembly Middle, Left".
28 Roller axis part of "Lever Assembly, Roller
Release, Right".
29 Pin of "Frame Middle, Right".
30 Stair parts of "Axis, Arm Lifter".
31 "U" shape ditches of "Paper Guide Unit" on
the both right and left sides.
Rev. A
No.
Type/Amount
32
G-26 ( 1mm x1/3 of
gear teeth)
33
G-26 ( 1x10mm)
34
G-26 ( 1mm x1/3 of
gear teeth)
G-26 ( 1x2mm)
G-20 ( 1x2mm)
G-20 ( 1x2mm)
G-20 ( 1x2mm)
G-26 ( 1x 1/4 of
gear teeth)
G-26 ( 1x2mm)
No.
1
0-8 (0.8cc)
2
G-26 ( 1x3mm)
G-26 ( 1x1mm)
G-26 ( 1x3mm)
G-26 ( 1x2mm)
G-26 ( 1x5mm top
and bottom)
Lubricating Points
Surface of "Axis, CR".
Note) Do not lubricate "Axis, CR, Support".
Holes on the axis of "Combination gears
29.6, 29.6".
Axis part that contacts with "Combination
gear 29.6, 29.6" and the "Assembly cap
board" to install "Combination gear 15.2,
23.2".
Note) Do not lubricate on an axis that
connects with the hole of "Pump Assembly".
of "Combination gear 15.2, 23.2".
Table 6-5. Adhesive Points
Adhesive points
Bottom part of plastic located under the
compression spring 0.98.
Fixing Screw for Upper Surface Sensor
Chapter6 Preventive Maintenance
Type/Amount
0-8 (Wipe with cloth
moisten with oil)
G-26 ( 1x5mm)
G-26 ( 1x5mm)
Amount
Half circle
1/3 of screw head
circumference
6-5