Epson Stylus Pro 5000 Service Manual page 150

Stylus Pro5000
3. Engage the teeth of "Gear,10" and the teeth of "Gear,24", inserting the
needle tip to the hole on the "Holder, Lever, Curl", and install "Gear,24".
(See figure4-142)
CHECK POINT
After installing "Gear,24", make sure that convex
side on the "Gear,10" and concave side on the
"Gear,24" match each other. If they don't match
each other, perform procedures from 1 to 3 again.
Rev. B
Chapter4 Assembly and Disassembly
Install "Gear,24", engaging the teeth
of "Gear,24" and "Gear,10"
From "Gear,24", pierce the nail
into "Holder, Lever, Curl"
Figure 4-142. Installing "Gear,24"
"Gear,10"
Figure 4-143. Matching Alignment of "Gear,10" and "Gear,24"
Convex Side
Concave Side
"Gear,24"
4-76