Epson Stylus Pro 5000 Service Manual page 162

Stylus Pro5000
34. Make sure that the harness from "Upper Surface Sensor" is under "Axis,
Paper Feed, Fixing", which was installed at procedure 33, and attach "E"
shaped ring to the ditch for fixing "E" shaped ring. (See figure4-167)
CAUTION
When attaching "E" shaped ring, fix the ring to the
ditch on the "Axis, Paper Feed, Fixing", which is
inside, not outside of "Lever, Roller, Paper Feed,
Left".
35. Reverse "ASF Unit" to its front face.
36. Rotate "Roller, Paper Feed" until it comes to stand-by position.
(Protrusion side comes top) (See figure4-168)
Rev. B
"Lever, Roller,
Paper Feed, Left"
"E" shaped ring
(4,F/Uc)
Figure 4-167. Fixing "Axis, Paper Feed, Fixing"
"Roller, Paper Feed" should be in
stand-by position.
Figure 4-168. Angle of "Roller, Paper Feed" Before installing "Driven
Chapter4 Assembly and Disassembly
Fix "E"-shaped ring
inside.
"Axis, Paper
Feed, Fixing"
Gear"
4-88