Upper Paper End Sensor Removal - Epson DFX-8000 Service Manual

3.2.7.7 Upper Paper End Sensor Removal

Step 1: Remove the loading solenoid. (Refer to section 3.2.7.5.)
Remove the external fan unit. (Refer to section 3.2.7.4.)
Step 2:
Step 3: Unhook the upper paper end sensor cable from the wire saddle, then disconnect the cable
from the terminal board. (See APPENDIX, Figure A-2.)
Remove the paper bail spring at the left frame side.
Step 4:
Step 5: Remove the paper bail gear. Remove the gear by pulling it Ieftward while lifting the clip section
with tweezers.
Step 6: Remove the E ring (6) securing the paper bail lever to the left side of the shaft,
the paper bail lever and shaft holder.
Paper Bail Lever -
Paper Bail Spring
Paper Bail Gear"
-
Wire Saddle
Terminal
Paper Bail Shaft
Figure 3-37. Paper Bail Removal (Left)
3-32
E ring (6)
and remove