Epson DFX-8000 Service Manual page 136

REV.-A
Remove the two CBS (0) (M4 X 6) screws securing the upper paper guide, then remove the
Step 10:
upper paper guide.
Remove the two CP (PS) (M3 X 6) screws securing the upper paper end sensor to the upper
Step 1 1:
paper guide, then remove the upper paper end sensor.
A S S E M B L Y P O I N T S :
When connecting the cable which was disconnected in Step 3 above to the connector on the terminal
board, refer to Figure A-2 "Terminal Board Cable Connections."
When attaching the leaf spring to the tension roller shaft, set the spring so that the bulge in the spring
is at the shaft holder side.
When attaching the upper paper guide, tighten the screws while pulling the paper guide downward
and leftward. (See Figure 3-40.)
When attaching the upper paper guide, withdraw the upper paper end sensor cable from the hole
in the left frame.
CBS (0)
/
Figure 3-40. Upper Paper Guide Removal
Upper Paper Guide
Figure 3-41. Upper Paper
6)
Guide Assembly
3-34
-Left Frame