Table 1-17. Dip Sw 3-5 And. 3-6 - Epson DFX-8000 Service Manual

Step 4: Turn on DIP switch 3-5 and turn off DIP switch 3-6. This tells the printer you want to save
information for multi-part forms that overlap slightly where they are joined together.
Overlapping
multi-part forms
Valid
b. Saving information for multi-part forms with labels
To save paper format and thickness information for multi-part forms with labels on them, follow the
steps below:
Step 1: Load the forms with labels on to the front tractor.
Turn off the printer. Be sure to close the top cover.
Step 2:
Step 3: Use DIP switch 3-4 to select the memory area where you want the printer to store the paper
format and thickness information.
Memory area 1 is selected when DIP switch 3-4 is off. This is the printers default setting. To
select memory area 2, turn on the switch.
(See Table 1-1 5.)
Use DIP switch 3-2 or software commands to set the page length. Page length. (See Table 1-1 6.)
Step 4:
Step 5: Turn off DIP switch 3-5 and turn on DIP switch 3-6. This tells the printer you want to save
information for multi-part forms with labels on them.
I
Overlapping
multi-part forms
Invalid
Step 6: Hold down both MICRO FEED buttons and turn on the printer.
The printer loads and checks the forms on the front tractor. When it is done, the printer beeps.
NOTE: Do not go on to the next step before the printer beeps.
Step 7: Open the top cover.
Table 1-17. DIP SW 3-5 and 3-6
DIP SW 3-5
ON
SW
Table 1-18. DIP
DIP SW 3-5
OFF
I
I
1-34
Multi-part forms
with labels
Invalid
3-5 and 3-6
Multi-part forms
with labels
Valid
DIP SW 3-6
OFF
DIP SW 3-6
ON
I
I
(