Platen Removal - Epson DFX-8000 Service Manual

3.2.7.9 Platen Removal

Remove the tension roller shaft. (Refer to section 3.2.7.8.)
Step 1:
Remove the four CPS (PS) (M4 X 8) screws securing the platen to the Platen holder and remove
Step 2:
the platen.
. When attaching the platen, tighten the screws while pulling the platen downward and Ieftward. (See
Figure 3-46.)
When connectin9 the cables which were disconnected in Step 2 of Section 3.2.7.8 to the connector
on the terminal board, refer to Figure A-2
The followin9 adjustments must be performed when the platen is removed:
. Bi-directional
Figure 3-46. Platen Removal
A D J U S T M E N T
Printin9 Adjustment (See section 4.3.)
Parallelism Adjustment (See section 4.4.)
Mechanism Adjustment Value Measurement (See section 4.6.)
"Terminal Board Cable Connections."
R E Q U I R E D
3-37