Epson DFX-8000 Service Manual page 133

R/F Change Lever Unit Disassembly
(
Remove the two CP (PS) (M3 X 6) screws securing the ribbon feed motor to the R/F change
Step 5:
lever unit, then remove the ribbon feed motor.
Disconnect the cable from the connector (black) on the ribbon feed motor.
Remove the E ring (3) securing the tractor select lever, then remove the tractor change lever.
Step 6:
Remove the E ring (3) securing the tractor select cam, then remove the tractor select cam.
Step 7: Remove the CP (S) (M2 X 10) screw securing the tractor select sensor, then remove the tractor
select sensor.
Step 8: Using nippers, cut the wire band fixing the ribbon feed motor and tractor select sensor cables
to the R/F change lever unit
A S S E M B L Y P O I N T :
When connecting the cables which were disconnected in Step 2 above to the connector on the
terminal board, refer to Figure A-2 "Terminal Board Cable Connections."
When attaching the tractor select lever to the tractor select cam, carefully observe the mounting
position shown in the Figure below
Lever Spring
Tractor Charwe Lever (Lower) -.----&
Figure 3-35. R/F Change Lever Unit Disassembly
Figure 3-36. Tractor Select Lever Mounting Position
"
\ l
Tractor Select Cam
I
3-31
-
Lever