Epson DFX-8000 Service Manual page 132

3.2.7.6 Ribbon Feed Motor and Tractor Select Sensor Removal
R/F Change Lever Unit Removal
Remove the external fan unit. (Refer to section 3.2.7.4.)
Step 1:
Step 2: Disconnect the ribbon feed motor and the tractor select sensor cables from the connectors
(white and yellow) on the terminal board. (See APPENDIX, Figure A-2.)
Remove the carriage damper (left), and remove the ribbon feed gear cover, then remove the
Step 3:
ribbon feed gear.
Damper, Left
Step4: Remove two CPS (P) (M3 X 6) screws securing the R/F change lever unit, then remove the
R/F change lever unit.
A S S E M B L Y P O I N T :
When attaching the R/F change lever unit, join the tip of the tractor select lever and the tractor select
gear holder correctly. (See CHAPTER 2, Figure 2-1 1.)
"
Figure 3-33. Damper, Left/Ribbon Feed Gear Removal
Figure 3-34. R/F Change Lever Unit Removal
3-30
Ribbon Feed Gear Cover
D: L. L--- C--..l c.. -.